- Product weight: 5 kg
- Product model: HL-YB-05
- Hot air module: PTC heating
- Power: 2000 W.
- Installation method: on the wall
- Function: space heating / drying clothes / disinfection / drying / cool breeze
- Press this function button. The engine is running at a low speed. The PTC heating block is activated at half power (1200 W). The screen shows that the drying time is 10 minutes. 10 minutes later the machine closes automatically. Close this function button. This drying setting is not effective. The machine is closed. Press this function key again if necessary to resume drying. After closing this function button, the PTC heating block operation stops immediately, but the engine continues to run for 30 seconds to remove waste heat from the box. 30s later the engine will stop working automatically.
Step 1 : Choose a location that is no more than 1.5 m from the power source.
In the toilet, choose the right place, which is not more than 1.5 m from the electrical outlet. Installation height is better when the eye is parallel to the installation position and aligned with the position of the touch screen switch. The associated area must be cleared.
Step 2 : Install the retaining plate and mark correctly.
Attach and install the setting plate and make the mark in the hollow position of the setting plate.
Step 3 : Repair the connector.
Properly glue the three fasteners to the marking position with a special adhesive (to the wall surface without ceramic tiles attach the hanger with screws). Please do not use too much glue. It is only required to apply a small amount of adhesive evenly.
Step 4 : Put the machine away after fastening the fasteners.
Temporarily attach the hanger with an additional sticker after locking one hanger. 48 hours later, the adhesive will completely form a permanent bond. Remove the auxiliary sticker and put the machine away.
Powerful waterproof function
- It can be placed in the bathroom, you do not have to worry about the impact of water, water resistance, strong warm air effect, it can continue to heat up, let the bathroom become spring in winter, make the bath more comfortable, life is better！
The heater overcomes the problem of eye damage and comfort
- First of all, the heater does not emit light, it can protect your eyes when bathing, and secondly, the heater works like warm air. It can evenly distribute warm air in the bathroom, providing excellent comfort, high power, fast heating in a short time and keeping fresh air.
- After starting any function, the user can press one key to close it. After starting the heating / drying function in the room, after pressing one button to turn off the main power, there is a 30s delay - heat dissipation. 30s later, the machine is automatically closed.
- Press this function button to start the engine (high gear) and immediately pull the cool breeze out of the air outlet (wind speed is up to 8 m). Close this function button to stop the engine, as well as a breath of cold breeze. This function is mainly used in the summer to immediately change the bathroom air environment.
Press this function key to start the engine (high gear). The PTC heating block is immediately started at high power (2400w), hot wind is removed from the air outlet, and the wind speed is up to 6-7 m for fast heating. Close this function button. The PTC heating block operation stops immediately, but the engine continues to run for 30s to remove waste heat from the box to protect the machine. 30s later the engine will stop working automatically.
1. To avoid overheating, do not cover the heater.
2. The heater cannot be placed directly under the power socket.
3. If the power cord is damaged, ask the manufacturer or a professional maintenance department or similar professional to replace it to avoid danger.
Select the appropriate area. Fasten the retaining plate. Apply the glue on and clean it and mark the hanging element accordingly
Glue the mark Remove
48 hours later, hang the machine positioning plate up